BIGTREETECH Manta M8P V2.0 Control Board

An Innovative and Easier Way to Run Your Klipper

Manta M4P/M5P/M8P are born for Klipper running, they allow a direct installation of the BIGTREETECH CB1/Raspberry Pi CM4 to run the Linux system, then the Klipper.

Board-to-Board Connector

Designed with the same connector as Raspberry Pi, giving you a confident connection with all versions of CM4, and definitely, CB1 or CB1 eMMC. A screw-reinforced installation is available, too.

Manta M8P V2.0

✅ Installed with 32-bit 550MHz ARM® Cortex-M0+ STM32H723ZET6 chip, the frequency is more faster.

✅ Designed with the same connector with Raspberry Pi, giving you a confident connection with all versions of CM4,definitely, CB1. Also, a screw-reinforced installation is also avaliable.

✅ It has rich expansion ports, can support various expansion modules, such as BL Touch, LCD screen, RGB light, auto shutdown, etc.

✅ TPS5450-5A Power Chip The 5A output perfectly matches the power supply need of Raspberry Pi.

✅ Selectable CNC fan voltage, 5V/12V/24V.

✅ Added eFuse circuit protection. It will faster disconnected on overload, and automatically reset if the overload is gone, which will greatly reduce the motherboard burnout caused by short circuits or ignition.

✅ Reserved Can Bus port can be connected with EBB CAN, which will simplify the wiring and provide strong  anti-interference ability.

Update:All new ID. Added I2C,5V Servo, Expanded IO, and TFT interface. Using 12V power solution. Optimized 5V power supply circuit.

🌟The M8P V2.0 & CB1 can be the best choice for Voron 2.4, VzBot, etc.