Generic Hotend with 0.4mm Brass Nozzle for Anycubic Kobra S1 / S1 Combo
Overview
A complete replacement hotend for the Anycubic Kobra S1 and Kobra S1 Combo. It comes with the 0.4mm brass nozzle, heater cartridge, thermistor and silicone sock already fitted, so you can swap out a worn or damaged hotend in one go. It is built for high-temperature, high-speed printing.
Key Features
Complete hotend assembly with 0.4mm brass nozzle
Heater cartridge and thermistor included
Silicone sock included to hold heat and protect the heater block
Made for the Anycubic Kobra S1 / S1 Combo extruder
In the Box
1 x Kobra S1 hotend with 0.4mm brass nozzle (heater cartridge, thermistor and silicone sock fitted)
Compatibility
Anycubic Kobra S1 and Kobra S1 Combo 3D printers. Please check that your printer is one of these before ordering.
Installation
Power off and unplug the printer and let the hotend cool fully before you start. Disconnect the old heater and thermistor wires, fit the new hotend, reconnect the wires and check the connections before powering on.
This is a generic replacement part and is not an original Anycubic product. Anycubic and Kobra are trademarks of their respective owner and are used only to indicate compatibility.